Installation - Zanussi ZEI3921IBA User Manual

Warning! If there is a crack on the surface,
disconnect power supply to prevent the electric
shock.
How to prevent a damage to the appliance
• If the objects or cookware fall on the glass ceramic, the
surface can be damaged.
• Cookware made of cast iron, cast aluminium or with
damaged bottoms can scratch the glass ceramic if you
move them on the surface.
• Do not let cookware boil dry to prevent the damage to
cookware and glass ceramics.
• Do not use the cooking zones with empty cookware or
without cookware.

Installation

Installation
Warning! You must read these!
• Make sure that the appliance is not damaged because
of transportation. Do not connect a damaged appliance.
If it is necessary, speak to the supplier.
• Installation and connection of the appliance to the
power supply must only be carried out by qualified
personnel.
• Only use built-in appliances after you assemble the ap-
pliance into correct built-in units and work surfaces
that obey the standards.
• Do not change the specifications or modify this prod-
uct. Risk of injury and damage to the appliance.
• Fully obey the laws, ordinances, directives and stand-
ards in force in the country where you use the appli-
ance (safety regulations, recycling regulations, electri-
cal safety rules etc.)!
• Keep the minimum distances to other appliances and
units!
• Install anti-shock protection, for example install the
drawers only with a protective panel directly below the
appliance!
• Prevent damage of the cut surfaces of the worktop
against moisture with a correct sealant!
• Seal the appliance to the worktop with no space left
with a correct sealant!
• Prevent damage of the bottom of the appliance from
steam and moisture, e.g. from a dishwasher or oven!
12
• Do not cover the parts of the appliance with aluminium
foil.
• Leave a ventilation space of 5 mm between the worktop
and front of the unit below it.
Disposal of the appliance
• To prevent the risk of physical injury or damage
– Disconnect the appliance from the power supply.
– Cut off the mains cable where it connects with the
appliance and discard it.
– Speak to your local authorised facilities for disposal
of your appliance.
• Do not install the appliance adjacent to doors and be-
low windows! If not, hot cookware can be hit off the
hob when you open doors or windows.
• Disconnect the appliance from the electrical supply,
before you do maintenance work or clean.
Warning! Risk of injury from electrical current.
Carefully obey the instructions for electrical
connections.
• The electrical mains terminal is live.
• Make electrical mains terminal free of voltage.
• Install correctly to give anti-shock protection.
• Loose and incorrect mains plug and socket connec-
tions can make the terminal become too hot.
• A qualified electrician must install the clamping con-
nections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains connection cable and replace the
damaged mains cable with proper special cable. Speak
your local Service Force Centre.
• The appliance must have the electrical installation
which lets you disconnect the appliance from the
mains at all poles with a contact opening width of min-
imum 3 millimetres.
• If the fixing bracket is near to the terminal block, al-
ways make sure the connection cable does not come in
contact with the edge of the bracket.
• You must have correct isolation devices: line protect-
ing cut-outs, fuses (screw type fuses removed from the
holder), ground leakage trips and contactors.
www.zanussi.com