Grill Assembly - Hunter 90438 Owner's Manual

GRILL ASSEMBLY

Note: The trim ring may be attached to the front and rear
grills for shipping purposes. If so, remove the trim ring by
loosening the trim ring screw.
1. Remove the four grill mounting screws from the
motor housing. Figure 11.
2. Make sure that the grill is positioned so that three
of the grill lines are completely between the top
tabs. Then place the Back Grill against the Motor
Housing, Figure 12., and line up the four tabs on
the back of the grill to the four screw holes on the
front of the motor.
3. To attach the Back Grill to the Motor Housing
partially install the four grill mounting screws.
Tighten all four screws. Figure 13.
Note: One of the grill mounting screws will have a star
washer on it, for grounding purposes. The other 3 screws
will not have a washer.
4. Loosen the screw on the back of the Blade assembly.
Figure 14a. Slide the Blade assembly onto the
motor shaft. Figure 14.
5. Tighten the Screw on the Blade assembly to secure it
to the Motor. Make sure that the end of the screw is
positioned within the notch on the shaft. Figure 15.
Caution: Ensure when tightening the screw on the back
of the fan blade, you tighten it on the flat part of the
motor shaft.
14a
Motor
Fan Blade
Figure 14
9
Grill
Mounting
Screw
1
2 3
Top Tabs
Grill Lines
Notch
Figure 11
Figure 12
Figure 13
Figure 15