Bryant Non-Programmable thermostat Owner's Manual page 14

Operating the Thermostat
2. Press it down. This will disconnect the thermostat
from the top of the wall plate.
3. Remove the thermostat from the wall bracket
completely by bringing it slightly toward you and
lifting it up and off the lip on the lower edge of the
wall bracket.
4. Set the thermostat face down on a flat surface. You
will see the batteries in the lower right corner.
5. Remove and discard the old batteries.
6. Install new batteries by matching the "plus" and
"minus" ends of the batteries with the "plus" and
"minus" indicators you'll see outside the two white
battery shapes in the space where the batteries sit.
7. Snap the batteries into place.
8. Put the thermostat back on the wall bracket by lining up the slot
on the bottom edge of the back of the thermostat with the lip on
the wall bracket. You will feel the slot fit over the lip.
12