General and Radio Controls Specifications Supply voltage : 12V DC(11V-15V) Current consumption : Less than 10A Audio Signal Output : 2ch line out Characteristics : (1) Frequency Response: 20Hz-20KHz AUX IN S/N Ratio: 50 dB(JIS) BAND LOUDNESS CLOCK MODE (Europe) (U.S.A.) SCAN REPEAT...
3. MODE (Input Select) Setting Mode Press this button repeatedly to cycle through the audio input sources: You can make changes to the system setting in the following area: AUX >TUNER > USB > CARD Radio Frequency Range + Enable/Disable AUX In+ Clock Format 4.
USB/SD Card (MP3 Playback) Controls Trouble Shooting Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. AUX IN BAND Symptom LOUDNESS Cause Solution The car ignition is not on.
Wiring connection diagram 6. SD CARD slot Insert SD card in this slot for playback. Please note icon on panel which shows you how to orient card (angled corner goes to left side of slot). 7. USB port BLUE (ANT) Insert USB drive in this slot for playback.
Installation dashboard attachment Operation of Remote Controller surface support strap 1.SOURCE(Input select, same as 5mm nut MODE on the head unit) support screw 2.EQ(Preset Equalizer Curves) mounting case Press repeatedly to cycle through these modes: FLAT, CLASSIC, ROCK, POP, USER SET. support screw 5x15mm support screw...