Custom Master Tv Setup; Before You Begin; Cloning Methods; Clonable Tv Setup Menu Features - LG Pro Centric 32LP645H Commercial Mode Setup Manual

This section describes how to create a customized Master TV Setup for cloning purposes when the TV is in
Pass-through Mode.
Note: Cloning requirements and procedures are described in detail on pages 34 to 42. Refer to "FTG Mode of
Operation Overview" on pages 43 to 44 for information on FTG Mode operation and configuration.

Before You Begin

• It is recommended that you disconnect all Aux
inputs if you intend to run Auto Tuning (Channel
Search). Under certain conditions, Auto Tuning
is disabled if there is an Aux input active.
• Determine which cloning tool—USB memory
device or clone programmer—is appropriate for
your application; several of the Master TV Setup
procedure steps are dependent on the cloning
tool to be used. See "Cloning Methods" at right
for further information.
• If you intend to use a USB memory device,
determine the type of file—either the new ".tlx"
file format or the legacy ".tll" file format—to use
for cloning purposes; several of the Master TV
Setup procedure steps are dependent on the
desired file type. See "Cloning Methods" at right
for further information.
• If the EZ-Manager Wizard appears on the screen,
exit the wizard before beginning/continuing the
Custom Master TV Setup procedure.

Clonable TV Setup Menu Features

Channel
Auto Tuning (Channel Lineup)
Manual Tuning
Channel Edit
Channel Label
Picture
Picture Mode *
*
Advanced Control (Picture Mode) and DST (Clock Mode) settings are cloned via .tlx file only.
Note: Some menu options vary between analog and digital channels and Aux inputs.
206-4232

Cloning Methods

See also "Clonable TV Setup Menu Features" list below.
Using a USB Memory Device / .tlx File
• The .tlx file format clones Installer Menu settings and all TV
sources' (analog, digital, AV1, HDMI, etc.) clonable setup menu
settings.
• Not intended for cloning an auto-tuned/edited Channel Map, as
the channel lineup is converted to a logical FTG Channel Map
when saved (Learned) from a TV to a .tlx file. If the .tlx file with
the FTG Channel Map is then used for Teaching purposes, all
Target TVs will be configured for FTG Mode via CPU.
Using a USB Memory Device / .tll File
The .tll file format clones the contents of the commercial controller
(PTC) memory, including an auto-tuned/edited Channel Map,
Installer Menu settings, and one TV source's (analog, digital, or
Aux) clonable setup menu settings.
Using a Clone Programmer (TLL-1100A or LT2002)
Both the TLL-1100A and LT2002 clone the contents of the
commercial controller (PTC) memory, including an auto-tuned/
edited Channel Map, Installer Menu settings, and one TV source's
(analog or Aux) clonable setup menu settings.
Audio
Auto Volume
Clear Voice
Sound Mode
Balance
TV Speaker

Custom Master TV Setup

Time
Clock Mode (Auto/Manual) *
Time Zone
Auto Off
Option
Language
Caption
Standby Light
29