Kenmore 153.318032 Owner's Manual page 13

6.
FIGURE 17.
The buss bar is labeled 5500 W. Place the buss bar over
terminals 2 and 3 with the 5500 W visible. Install the extra
screw provided into terminal 3.
Fire and Explosion Hazard
• Thermostat must be flush
against thetank.
• Make sure terminal cover is in
place and the insulation
replaced.
o Failure to do this could result in
death, serious bodily injury, or
property damage.
Make sure the thermostat is flush against the tank, the terminal
cover is in place, and the insulation is replaced. Failure to
do so can result in DEATH, SERIOUS BODILY INJURY, OR
PROPERTY DAMAGE.
10. Replace the insulation block so that it completely covers the
thermostat and element.
7.
FIGURE 18.
The wire removed from terminal 2 has a looped end. It must
remain looped and now be placed (as shown) on top of the
buss bar, over the opening of terminal 2, and secured using
the remaining screw.
FIGURE 20.
11. Replace the access panel.
8.
FIGURE 19.
Tighten terminals 2 and 3 to ensure proper electrical
connection.
Fire and E×plosion Hazard
• Failure to tighten screws can
cause a fire.
= Failure to do this could result in
death, serious bodily injury, or
property damage.
Failure to tighten terminal screws can cause a fire which can
result in DEATH, SERIOUS BODILY INJURY, OR PROPERTY
DAMAGE.
9. Replace terminal cover on thermostat making sure that the
locking tabs on the terminal cover are in place.
FIGURE 21.
12. Complete wiring to the water heater, or if completed, turn
"ON" electric power to the water heater after filling the tank
with water.
I3
FIGURE 22.