AOR AR2700 Operating Manual page 47

The search process takes place from the
displayed frequency using the receive
mode and step size displayed.
If the default mode of PROGRAM "PROG"
has been selected, then the receive
mode and channel step will change
automatically depending upon the
automatic bandplan data programmed
into the AR2700 during manufacture.
Example of manual search
For example, to search manually from
145.000 MHz key [1] [4] [5] [ENT] in
MANUAL mode then press and hold the
[UP] key for more than 1.5 seconds.
Changing the direction of manual search
Depending upon the key used to initiate
the MANUAL SEARCH, the receiver may
be automatically searching upward or downward. The direction of search may
be reversed by rotating the [DIAL] or using the UP / DOWN keys.
Moving on from active frequencies
Should the receiver stop on an active frequency during manual search, you
may force the manual search process to continue by pressing the UP / DOWN
keys or rotating the [DIAL].
To cancel manual search and transfer to manual mode
To cancel manual search press [MANU], the current displayed frequency will
be transferred to the VFO frequency in manual mode where it may be
monitored or tuned.
Writing active frequencies to memory and continuing manual search
If an interesting active frequency is found while in manual search mode, it may
be written to a memory channel.
Press and hold the [ENT] key for more than 1.5 seconds to enter memory
write mode.
The legend "BANK" and "CH" will be
displayed in the upper left corner of the
LCD to confirm that memory write is in
progress.
The first available empty memory location
will automatically be offered. To write the
frequency into this memory location
simply press [ENT].