Troubleshooting; Before Calling; For Service - LG LRE30453SW Owner's Manual & Cooking Manual

TROUBLESHOOTING
BEFORE CALLING FOR SERVICE
Before you call for serdce, rmiew this list. It may save you time and expense. The list includes common occurrences that are not
the result of defective workmanship or materials in this appliance.
be
Problem
Range is not level.
Possible cause / Solution
• Poor installation. Place oven rack in center of oven. Place a level oll the oven rack.
Adjust leveling legs at base of range until the oven rack is level.
• Be sure floor is level and is strong and stable enough to adequately suppoit range.
• If floor is sag_ng or sloping, contact a carpenter to correct the situation.
•Kitchen cabinet alignment may make range appear unlevel. Be sure cabinets are square
and have sufficient room for range clearance.
Ca n
not move a
pplia nce
• Cabinets not square or are built in too tightly. Contact builder or installer to make appliance
easi ly.
accessible.
Applia
nce m ust be • Carpet interferes _ith range. Prodde sufficient space so range can be lifted over carpet.
.... .......................................................................................................
Oven control beeps and
displays any F code error.
•
Electronic control has detected the fault
CODE
condition. Press CLEAR/OFF to clear
F-1
the display and stop beeping.
1=-2
Reprogram oven. If fault recurs, record
fault number. Press CLEAR/OFF and 1=-3
1=-4
contact a Senice agent
1=-7
CAUSE
Shorted keypad
Door locking system don't operate
Open oven sensor
Shorted oven sensor
No heating
F-9 Oven =stoo hot
Surface units will not
• hnproper
coohvare being used.
maintain a rolling boil or
- Use pans which are flat and match the diameter of the sufface unit selected.
cooki ng is not fast
• In some areas, the power (voltage) may be low.
e no ugh
- Cover pan _ith a lid until desired heat is obtained.
Surface units do notwork . A fuse in vour home mav be blown or the circuit breaker tripped.
properly
- Replace the fuse or reset the circuit breaker.
• Cooktop controls improperly set.
............................................................................. .........................................
Surface
u nit
stops
• This is normal. The unit is still on and hot.
glowing when changed
to a lower
setting
Areas of discoloration on • Food spillovers not cleaned before next use.
the cooktop - See Cleaning the glass cooMop section.
• Hot surface on a model _ith a light-colored cooktop.
- This is normal. The surface may appear discolored when it is hot. This is tempora Wand
_ill disappear as the glass cools.
Frequent cycling on and .Thisis normal.
off of
s u
rface
u n
its
- The element x\ill cycle on and off to maintain the heat setting.
-32-