Fujitsu Stylistic Q552 Bios Manual page 24

S T Y L I S T I C Q 5 5 2 B I O S
EXIT MENU – LEAVING THE SETUP UTILITY
The Exit Menu is used to leave the setup utility. Follow
the instructions for Navigating Through the Setup
Utility to make any changes. (See Navigating through
the Setup Utility on page 2 for more information.)
Info System
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Discard Changes
Save Changes
Save Changes and Power Off
F1 Help
ESC Exit
Table 17: Fields, Options and Defaults for the Exit Menu
Menu Field Description
Exit Saving Exit Saving Changes and Exit will store all the entries on every menu of the setup utility to the BIOS memory,
Changes then exit the utility. A confirmation message Save Configuration changes and exit now?
[Yes][No] is displayed.
Exit Discard- Selecting Exit Discarding Changes and Exit will exit the setup utility without writing to the BIOS memory.
ing Changes When the BIOS recognizes this selection it will reboot, load the operating system and begin operation.
Load Setup Selecting Load Setup Defaults will load the factory preset default values for all menu fields, then display the
Defaults message Load default configuration now? [Yes] [No]. When confirmed the setup utility
will return to the Exit Menu. To return to another menu follow the directions in the Navigating Through the
Setup Utility Section.
Discard Selecting Discard Changes will load the previous values in BIOS memory for all menu fields. The message
Changes
Load
previous configuration now? [Yes] [No] will be displayed. When confirmed the setup utility
will return to the Exit menu. To return to another menu, follow the directions in the Navigating Through the
Setup Utility Section.
24
Phoenix SecureCore(tm) Tiano Setup
Advanced Security
Select Item -/+ Change Values
/
Select Menu Enter Select ► Sub-Menu
/
Figure 17. Exit Menu
The following table shows the names of the menu
fields for the Exit menu, the default settings and a
description of the field's function and any special
information needed to help understand the field's use.
Boot Exit
Exit System Setup and
save your changes to
NVRAM.
Shift + 1 Enable or disable(!)
F10 Save and Exit
Item Specific Help