Indicator Of Program Sequence; Childproof Lock; Selecting A Different Program; Cancel Program - Bosch WTB86200UC Use And Care Manual

If Check drain indicator lights up, check the drain
▯
hose and its connection.
~ Maintenance of drain hose; Page 27
If required, select Low Heat by pressing the button.
3.
~ Additional options; Page 19
If required, select Wrinkle Block by pressing the
4.
button.
~ Additional options; Page 19
Tip: The estimated remaining time will be updated.

Indicator of program sequence

The dryer uses an electronic control system. A moisture
sensor continuously checks the moisture in the laundry.
Drying ends automatically as soon as the selected
degree of dryness has been reached.
The drum continues to rotate at specific intervals for one
hour to prevent creasing.
The current state of the process and level reached during
the program sequence is indicated by indicator lights
(dry, damp, regular).

Childproof lock

You can secure the dryer against inadvertent changing of
the set functions. To do this, activate the childproof lock
after cycle start.
To Activate/Deactivate, press Start/Pause for approx. 5
seconds. In the display field, you will see the
light indicating the childproof lock is active.
NOTICE: The childproof lock will remain activated until
the next cycle start even after switching the machine off.
You must deactivate the childproof lock before the next
cycle and, if necessary, activate it again after starting the
cycle.

Signal

For switching the buzzer on and off press the Signal
button.
The Buzzer indicates program end if it is activated.
Other alarms are not influenced by this option.
24

Selecting a different program

If you have inadvertently started the wrong program, you
can change this as follows:
Press Start/Pause.
1.
Select another program.
2.
Press Start/Pause. The new drying cycle starts from
3.
the beginning.

Cancel program

If required, you can cancel the selected program:
Press Start/Pause.
1.
Rotate the program selector to Off.
2.

Program end

End appears in the display area, the Start/Pause button
indicator lamp is off and the regular indicator lights up.
After the program end, rotate the program selector to
Off.
Removing laundry/switching the
appliance off
Open the door and remove the laundry.
1.
Turn the program selector to the Off position.
2.
Appliance is switched off and dryer light goes out.
Clean lint filter.
3.
~ Cleaning the lint filter; Page 25
symbol
D
Close the door.
4.
Tip: If at the end of the drying cycle the display does not
light, the energy-saving mode is active. To see diplay,
e.g. press any button.
~ Environmentally friendly use of your dryer; Page 7