Exponent - Haier HSU109VHG-G Service Manual

7.Exponent

Indoor Unit
Inlet
Front Cover
Outlet
Vertical louvers
Horizontal louver
(adjust left and (adjust up and
right air flow) down air flow
Don't adjust it
manually)
The unit pictured above is for reference only.
Your product may appear different.
Display board
1 2
1
Signal receiver hole
2
ON/OFF display
3
Ambient temp.display
When receiving the remote
control signal, display the set
temperature will be shown in the
display. The room temperature is
displayed and this room
temperature is only for reference.
Outdoor Unit
OUTLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
INLET
The unit pictured above is for reference only.
Your product may appear different.
Parts and Functions
Air Purifying Filter
(inside)
Emergency
Display
Switch
board
4
5
3
4
TIMER ON display
TIMER OFF display
SLEEP display
Note to the Auto restart function:
Press the sleep button ten times in five seconds
and enter the function after hearing four sounds.
Press the sleep button ten times within five
seconds and leave this function after hearing
two sounds.
5
COOL\HEAT\DRY\ AUTO display
4
Remote Control
1
2
3
4
5
9
10
11
12
13
14
15
16
17
1. Mode display
Operation mode
HEAT
A U T O COOL DRY
Remote controller
2. Signal sending display
3. SWING display
4. FAN SPEED display
Display
circulated
AUTO
LO MED HI
5. LOCK display
6. TIMER OFF display
TIMER ON display
7.TEMP display
8. Additional functions display
Operation mode QUITE SLEEP HEALTH
Remote controller
Healthy function is not available for some units.
Inserting the Battery
4
Then put on the cover again.
Note:
The distance from the remote to the receiver should be less than
23 feet (7 meters) with no obstructions.
Fluorescent lights or cordless telephones will reduce the range
of the remote.
If the display is dim the remote batteries may need to be replaced.
Remote malfunctions can sometimes be corrected by removing
the batteries for a few minutes and then replacing them.
Hint:
Remove the batteries if the unit won't be in use for a long period. If
there is any display after taking-out the batteries, just press reset key.
56
Exponent
6
9. QUIET button
10. HEAT button
11. COOL button
7
12. AUTO button
13. FAN button
14. TIMER button
15. HEALTH button
8
16. LOCK button
18
Used to lock buttons and LCD display.
17. LIGHT button
Control the lightening and extinguishing
19
of the indoor LED display board.
20
18. POWER ON/OFF button
19. DRY button
21
20. TEMP button
21. SWING button
22
22. HOUR button
23. EXTRA FUNCTION button
23
Function Fan Mode— Healthy
24
airflow upwarder — Healthy airflow
downwarder— Reset the healthy
25
airflow position — Right & left airflow
setting— A-B yard— 10
temperature heating— Sleep Mode—
F A N
Electrical Heating— Refresh Air—
Power — Fahrenheit/Celsius mode
shift on unit and remote
Remark A-B yard, Right & left airflow
setting, 10 low temperature heating,
Electrical Heating, Refresh Air functions
are not available for this mini split series.
24.CANCEL/CONFIRM button
Function: Setting and cancel to the
timer and other additional functions.
25. RESET button
If the remote is not functioning properly,
use a pen point or similar object to
POWER
depress the button to reset the remote
1
Remove the battery cover;
2
Insert the batteries as illustrated.
2 AAA batteries.
3
Be sure battery polarity is
correct
+ -.
Domestic Air Conditioner
low