Specification - Vox TB18C1 Owner's Manual

3. FX Loop Send Jack
Connect this to the input of your effect.
4. FX Loop Return Jack
Connect this to the output of your effect.
5. MAINS INPUT Connector
This is where the supplied, detachable Mains (power) cord is connected.
NOTE! Use only the power cable that is included with the TB18C1. Using another power cable
may cause malfunctions.
The specific mains input voltage rating that your amplifier needs to run at is located on the rear
panel of your amplifier. Before making any connections or powering up the amplifier, make sure
the correct voltage is set. If you have any doubt, refer to your local VOX dealer.
Controls:
I/O:
Tube Complement:
Output Power:
Speaker(s):
Dimensions (W x D x H): 588 x 257 x 552 mm / 23.15 x 10.12 x 21.73 inches
Weight:
Accessory:
Specifications and appearance are subject to change without notice for improvement.
6

Specification

Volume (preamp), Bass, Mid, Treble, Reverb, Master volume, Mid
Boost, Dark switch, Master Volume
Guitar Input High and Low, External speaker out, Extension speaker
out, FX Loop Send, FX Loop Return
2 x ECC83/12AX7, 2 x 6V6
18Watts RMS
1 x 12" 16ohm Celestion G12-65
17.8 kg / 39.24 lbs.
Power cable, Owner's manual
3 4