GE JBP64 Owner's Manual page 29

ge.com
¸, !
"F- anda number
or letter" flash
in the display
Possible Causes
You have a function
error code.
What To Do
• Disconnect all power to the range tot at least 30
seconds and then recolmect power. If the flmction
error code repeats,
call
tor service.
• On
sellXcleaning inodels, if a flmction error code
appears during the sell=cleaning cycle, check the oven
door latch. The latch inav have been inoved, it only
slightly, ti'Oln the locked position. Make sure the latch
is moved to the right as thr as it will go. Press the
CLEAR/OFFpad.
_Mlow the oxen to cool tor one hour.
Put the oven back into operation.
Display flashes "bAd"
The installed cmmection • Contact installer or electrician to correct miswire.
then "linE" with a from the house to the unit
loud tone is miswired.
Displaygoesblank
A fuse in your home may be • Replace the fl/se ()r reset the circuit breakel:
blown or the circuit
breaker tripped.
The clock is turned off from • See the Using the clock
and timer
section.
showing in the display.
Display flashes
Power failure. • Reset the clock.
Unable to get the Oven control pads were • The BAKE and BROIL HI/LO pads must be pressed
display to show "SF"
not pressed properly,
at the S_Illle tiIne alld held fOl"3 seconds.
Power outage,
Power outage or surge. • Reset the clock. If the oven was in t/se votl l//tlSt reset
clock flashes it bv _ressing the CLEAR/OFFpad,, , l , settin,_ the oh)ok
and resetting any cooking flmction.
"Burning" or "oily" This is normal in a new • To speed the process, set a self=clean cycle for a
odor emitting from
oven mad will disappear minimum of 3 hours. See the
Using the self-cleaning
the vent
in time.
oven section.
Strong odor
An odor from the insulation • This is
tell/lJOl'aÀ'v.
around the inside of the
oven is normal for the first
few times the oven is used.
29