Miele KM 6322 Operating And Installation Instruction page 73

Solid wood, tiled and glass
worktops
Preparing the worktop
Worktop
Hob
Gap
Wooden frame 13 mm
(to be provided on site)
As the ceramic glass and the
worktop cut-out have a certain
dimensional tolerance, the size of
gap can vary (min. 1 mm).
^ Make the worktop cut-out as shown
in "Building-in dimensions".
Observe the safety distances (see
"Safety instructions for installation").
^ Fix the wooden frame
below the top edge of the worktop
(see diagram).
Connecting the mains cable to the
appliance
The mains cable must only be
connected to the appliance by a
qualified and competent electrician
in strict accordance with current
local and national safety regulations
(BS 7671 in the UK).
^ Follow the instructions in the wiring
Installing the hob
^ Feed the mains connection cable
^ Centre the hob
^ Connect the hob to the mains.
^ Check that the hob works.
^ Seal the remaining gap
Observe the silicone sealant
manufacturer's instructions.
For granite and marble tiles, only
use silicone sealant that has been
especially formulated for granite and
7 mm
marble.
Flush-fitted hobs
diagram (see "Electrical connection -
Wiring diagram").
down through the cut-out.
silicone sealant that is heat-resistant
to at least 160 °C.
in the cut-out.
with a
73