Hamilton Beach 2202 Use & Care Manual page 9

IMPORTANT: Set both power switches (on the back of the dispenser) to the OFF position and
unplug the water dispenser before cleaning.
Use a solution of warm water and baking soda (approximately one tablespoon of baking soda to
one quart of water). This will clean and neutralize odors. Then rinse and wipe dry.
Other parts of the storage compartment including door gaskets and plastic parts can be cleaned in
the same manner.
NOTICE: To prevent damage to the water dispenser, the plastic storage parts are not to be
washed in the dishwasher.
Draining Instruction:
The dispenser should be drained before cleaning the tanks and before leaving for long vacations or
absences.
1) Set both power switches (on the back of the dispenser) to the OFF position and unplug
the dispenser.
2) Dispense water from both buttons into container(s) until no more water can be
dispensed (about 1 quart of water still remains in the dispenser). Put a container that
will withstand hot water under the hot water faucet.
3) Remove the water bottle from the dispenser.
4) Place a large bucket beneath the drain outlet on the rear of the dispenser.
5) Using a Phillips screwdriver, loosen the screws on the bracket covering the drain outlet
cap. Rotate the bracket out of the way to allow access to the cap.
6) Remove the cap and silicon stopper from the drain outlet and allow water to drain.
8