Hamilton Beach 2202 Use & Care Manual page 11

4) Remove the plastic separator by pulling straight out (you may need to twist slightly to
loosen).
5) Clean the separator with dish soap and water or in the top rack of the dishwasher.
6) Dry the separator thoroughly on both sides.
7) Using a clean cloth or paper towel, thoroughly dry the cold water reservoir.
8) Place the separator back in the dispenser. Make sure the long, tapered end of the separator
is positioned firmly on the metal plug on the bottom of the reservoir.
9) Replace the support collar and turn clockwise until it is firmly in place.
10) Install a full water bottle on the dispenser (see Preparing and Loading Your Dispenser for
Use).
Sanitizing and Cleaning the Water Tanks:
Important: Periodically the water dispenser tanks must be sanitized to prevent unpleasant tastes in
the water and cleaned to remove mineral deposits that can impair flow.
To Sanitize:
Important: Before cleaning, set both power switches (on the back of the dispenser) to the OFF
position and unplug the water dispenser. Note: For first time installation, skip next three steps.
1) Empty the water bottle, then remove it from the dispenser.
2) Drain the water tanks (see Draining Instruction)
10