Kenmore Sears Vacuum Cleaner Owner's Manual page 17

WARNING
Electrical Shock Or Personal injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result in elec-
trical shock or personal injury from
cleaner suddenly starting.
................ i..... , , _ _ _u,:,,,,,,,,,,,,,,,,,,,, .....
TO REMOVE LIGHT BULB:
Disconnect power cord from electrical out-
let.
Light
Lens
Slots
Pry light lens
out at slot in
rear as shown
on both sides.
Rotate lens up
and lift off,
CAUTION
Do not use a bulb rated over 15W.
During extended use, heat from the
bulb could overheat surrounding
plastic parts.
Remove the
light bulb by
pushing the
bulb in while
turning coun-
terclockwise to
release from
the slot.Then
pull the light
bulb straight
out.
To Release
\
To replace the
light bulb care-
fully insert and
turn clockwise
to securely fit
into slot,
NOTE: See PARTS AND FEATURES for
bulb #°
1
Do not p!ug in or turn on until the
vacuum ,s completely reassembled.
......... i,, ,11,, ir
To replace light
tens, place tabs
at front of tens
into slots, Rotate
lens down and
snap into place. Light
Lens
To maintain efficient cleaning, the agitator
must be kept free of carpet pile, string, or
hair build-up,, After every 7 to 10 uses,
unplug and turn vacuum over and check
agitator for sting and hair build-up,
Use a scissors to remove any build-up
entangled around the agitator
17