Epson G6050W User Manual page 107

10. Adjust the projector's position and use the lens shift option to center the image over the corner of the
wall or the point where the two surface areas meet. (The rest of these steps shows Horizontal
Corner as the selected Corner Type but the workflow is the same for Vertical Corner.)
Note: You can press Enter to show or hide the image and grid to check the results.
11. Use the arrow buttons on the projector or the remote control to select the area you want to adjust.
Then press Enter.
Tip: When Horizontal Corner is selected, adjust the top area by using the lowest point (indicated by
the blue arrow) as your reference and adjusting the areas indicated by the top two black arrows.
Adjust the lower area by using the highest point (indicated by the red arrow) as your reference and
adjusting the areas indicated by the bottom two black arrows.
107