Related Manuals for Epson XP-610
Summary of Contents for Epson XP-610
- Page 1 Epson NPD4921-00 EN Hardware Setup Guide Hardware Setup Guide Unpacking Step 1 Remove all protective materials. Step 2 Close the scanner unit slowly. Caution; must be followed carefully to avoid bodily injury.
-
Page 2: Turning On The Printer
Epson NPD4921-00 EN Hardware Setup Guide Turning on the Printer Step 1 Connect the power cable and plug it in. Step 2 Turn on the printer and raise the control panel. If an error occurs check that no protective material has been left inside the printer. -
Page 3: Selecting A Language
Epson NPD4921-00 EN Hardware Setup Guide Selecting a Language Go to the printer, and then follow the instruction to select your language. Installing Ink Cartridges Step 1 When instructed to install the cartridges, open the scanner unit. Do not touch the white flat cable inside the printer. - Page 4 Epson NPD4921-00 EN Hardware Setup Guide Step 2 Gently shake only the BLACK (BK) cartridge four or five times. Do not shake Photo Black (PBK) or other color cartridges. Remove all ink cartridges from their packaging. ❏ For the initial setup, make sure you use the ink cartridges that came with this printer. These cartridges cannot be saved for later use.
- Page 5 Epson NPD4921-00 EN Hardware Setup Guide Step 4 Insert each ink cartridge diagonally into the cartridge holder and gently push it down until it clicks into place. Step 5 Close the scanner unit slowly.
- Page 6 Epson NPD4921-00 EN Hardware Setup Guide Step 6 The following information is displayed on the printer’s screen while the printer is charging the ink. Wait until the charging is finished. The initial ink cartridges will be partly used to charge the print head. These cartridges may print fewer pages compared to subsequent ink cartridges.
-
Page 7: Loading Paper
Epson NPD4921-00 EN Hardware Setup Guide Hardware Setup Guide Loading Paper Step 1 Make sure the printer's control panel is displaying the home screen as shown below, and then open the front cover and pull out the lower cassette (paper cassette 2). - Page 8 Epson NPD4921-00 EN Hardware Setup Guide Step 3 Load A4 paper toward the edge guide with the printable side face-down, and check that the paper is not sticking out from the end of the cassette. Step 4 Slide the edge guides to the edges of the paper.
- Page 9 Epson NPD4921-00 EN Hardware Setup Guide ❏ XP-710 Series: The output tray is automatically ejected. When you finished printing, close the tray manually. ❏ XP-610 Series: You need to pull out and close the output tray manually.