Installation Procedure - Kenwood DNN9230DAB Quick Start Manual

Quick Start Guide

Installation Procedure

Supplied accessories
First of all, make sure that all
accessories are supplied with the
unit.
1 ...1
2 ...1
3 ...2
4 ...1
5 ...1
6 ...1
(3.5 m)
7 ...1
8...1
(3 m)
9 ...1
(3 m)
0 ...1
26
EN
Unit
1 To prevent a short circuit, remove
the key from the ignition and
disconnect the ¤ terminal of the
battery.
2 Make the proper input and
output wire connections for each
unit.
3 Connect the wire on the wiring
harness.
4 Take Connector B on the wiring
harness and connect it to the
speaker connector in your vehicle.
5 Take Connector A on the wiring
harness and connect it to the
external power connector on your
vehicle.
6 Connect the wiring harness
connector to the unit.
7 Install the unit in your car.
8 Reconnect the ¤ terminal of the
battery.
9 Press the <Reset> button.
(P.4)
10 Perform the Initial Setup.
See First Step (P.7).
NOTE
• Make sure that the unit is installed securely
in place. If the unit is unstable, it may
malfunction (eg, the sound may skip).
Bend the tabs of the
mounting sleeve
with a screwdriver
or similar utensil and
attach it in place.