Kenwood DNN9230DAB Quick Start Manual page 28

Quick Start Guide
Microphone unit and Push-To-
Talk Switch
1) Check the installation position
of the microphone (accessory
8) and the Push-To-Talk switch
(accessory 9).
2) Clean the installation surface.
3) Install the microphone.
4) Wire the microphone cable up to
the unit with it secured at several
positions using tape or other
desired method.
Fix a cable with a commercial item of tape.
Remove the separator of the
microphone, and stick the
microphone to the place shown
above.
Adjust the direction of the
microphone to the driver.
8
9
28
EN
NOTE
• Install the microphone as far as possible
from the cell-phone.