What Is Waas - Garmin GPSMAP 276C Owner's Manual

• Using WAAS: WAAS capability is enabled and the unit is
receiving WAAS corrections.
• Check Beacon Wiring: The DGPS setting is enabled in the
Com 1 or 2 tab of the Main Menu but no DGPS device is
detected.
• No Beacon Signal: DGPS receiver is attached, but not
transmitting RTCM data to GPS.
• Tuning Beacon: The receiver is tuning manually to a DGPS
frequency.
• Using Differential: The unit is receiving DGPS corrections.
• Scanning for Beacon: The DGPS receiver is scanning for an
available frequency.

What is WAAS?

The Wide Area Augmentation System (WAAS) is an FAA-funded
project to improve the overall integrity of the GPS signal and
increase position accuracy for users in North America.
The system is made up of satellites and approximately twenty-five
ground reference stations positioned across the United States that
monitor GPS satellite data. Two master stations, located on either
coast, collect data from the reference stations and create a GPS data
correction message.
GPSMAP 276C Owner's Manual
According to the FAA's Web site, testing in September 2002 of
WAAS confirmed an accuracy performance of 1–2 meters horizontal
and 2–3 meters vertical throughout the majority of the continental
United States and portions of Alaska.
WAAS is just one service provider that adheres to the MOPS
(Minimum Operational Performance Standard) for global Satellite
Based Augmentation Systems (SBAS). Eventually, there will
be several services of worldwide geostationary communication
satellites and ground reference stations.
All SBAS systems use the same receiver frequency; therefore, any
operational SBAS system should be capable of providing your GPS
unit with increased accuracy at any location in the world.
Currently, enabling WAAS on your Garmin GPSMAP 276C in
regions that are not supported by ground stations may not improve
accuracy, even when receiving signals from an SBAS satellite. In
fact it can degrade the accuracy to less than that provided by GPS
satellites alone. For this reason, when you enable WAAS on your
Garmin GPS receiver, the receiver automatically uses the method
that achieves the best accuracy. To enable WAAS, refer to page 6.
For more information, go to http://gps.faa.gov/Programs/WAAS/
waas.htm.
A > L GPS
PPENDIX EARNING ABOUT
109