How To Keep Your Oven In Shape - Ariston MB 91 Instructions For Installation And Use Manual

Timer knob (D)
To use the timer, you must wind the alarm by turning the
knob almost one complete turn clockwise; then turn the
knob back to set the time by positioning the minutes
required on the index of the facia.
Before cleaning your oven, or performing
maintenance, disconnect it from the power supply.
To extend the life of your oven, it must be cleaned
frequently, keeping in mind that:
• The self-cleaning panels (if present) and the
enameled parts should be washed with warm water
- abrasive powders and corrosive substances should
be avoided;
• The inside of the oven should be cleaned immediately
after use with warm water and soap; the soap should
be rinsed away and the interior dried thoroughly;
• Stainless steel can be stained if it remains in contact
with agressive detergents (containing phosphorus)
or water with a high lime content. We recommend
that you rinse these parts thoroughly and dry them
well after cleaning. It is also a good idea to dry any
water spills;
• Never line the bottom of the oven with aluminium foil
because the buildup of heat will not only impede the
cooking process, but could also damage the enamel.
Replacing the Lamp in the Oven
• Cutoff the supply of power to the oven by turning off
the omni-polar switch connecting it to the mains, or
by removing the plug if it is accessible;
• Unscrew the glass cover attached to the lamp holder;
• Unscrew the lamp and replace it with another high-
temperature lamp (300
characteristics:
- Voltage: 230/240 V
- Wattage: 15W
- Socket: E14
• Remount the glass cover and reconnect the
appliance to the power supply.

How to Keep Your Oven in Shape

°
C) with the following
Protective kit
During operation, the door and adjacent parts of the ap-
pliance become very hot. Ensure that children are kept
out of reach. To obtain a copy of the supplementary safety
kit provided by our Central Office and Authorized Service
Centers (see attached directory), request the "Children
Safety Kit" model BAB-MB 91 (IX) / (BK).
Disassembling/assembling the oven door
To make it easier to clean the inside of your oven, the
oven door can be removed, by proceeding as follows
(fig. 1-2):
• Open the door completely and lift the 2 levers "B" (fig.
1);
• Now, shutting the door slightly, you can lift it out by
pulling out the hooks "A" as shown in figure 2.
To reassemble the door:
• With the door in a vertical position, insert the two
hooks "A" into the slots;
• Ensure that seat "D" is hooked perfectly onto the
edge of the slot (move the oven door backwards
and forward slightly);
• Keep the oven door open fully, unhook the 2 levers
"B" downwards and then shut the door again.
11
Fig 1
Fig 2