Fellowes POWERSHRED M-8C Instructions page 2

A.
B.
C.
D.
CAPABILITIES
Will shred: Paper, credit cards, staples and paper clips
Will not shred: Continuous forms, CD/DVDs, adhesive labels, transparencies, newspaper,
cardboard, laminates, X-rays or plastic other than noted above
Paper shred size:
Cross-Cut .................................................................................................... 4mm x 50mm
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Operation, maintenance, and service requirements are covered in the instruction
manual. Read the entire instruction manual before operating shredders.
• Keep away from children and pets. Keep hands away from paper entry. Always set
to off or unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from
shredder openings. If object enters top opening, switch to Reverse (
back out object.
15
• Never use aerosol products, petroleum based lubricants or other flammable
products on or near shredder. Do not use canned air on shredder.
15
• Do not use if damaged or defective. Do not disassemble shredder.
Do not place near or over heat source or water.
15
E
F.
G.
KEY
A. Shredder head
B. Safety Lock
C. Window
D. Bin
Maximum:
Sheets per pass ............................................................................................................. 8*
Cards per pass ............................................................................................................... 1*
Paper entry width .................................................................................................. 230mm
* A4 (70g), paper at 220-240V, 50/60 Hz, 1.6Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates: 60 sheets;
5 cards. 8 sheets per pass.
• This shredder has a Disconnect Power Switch (E) that must be in the ON ( )
position to operate shredder. In case of emergency, move switch to OFF (O)
position. This action will stop shredder immediately.
• Avoid touching exposed cutting blades under shredder head.
• Shredder must be plugged into a properly grounded wall outlet or socket of the
) to voltage and amperage designated on the label. The grounded outlet or socket
must be installed near the equipment and easily accessible. Energy converters,
transformers, or extension cords should not be used with this product.
• FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
• For indoor use only.
• Unplug shredder before cleaning or servicing.
E Disconnect power switch G. Control switch and LEDs
1. OFF
I 2. ON
F. See safety instructions
ENGLISH
Model M-8C
1. Auto-On (green)
2. OFF
3. Reverse
4. Overheat (red)
15