Frigidaire FPUH19D7LF Specifications page 3

Built-In All-Freezer Specifications
• Product Weight – 247 Lbs.
An electrical supply with grounded three-prong receptacle is required.
•
The power supply circuit must be installed in accordance with current
edition of National Electrical Code (NFPA 70) and local codes &
ordinances.
• Voltage Rating – 120V / 60 Hz / 20 Amps
Connected Load (kW Rating) @ 115 Volts = 0.55 kW
•
• Amps @ 115 Volts = 5 Amps
• Always consult local and national electric & plumbing codes.
• Water line for ice maker can enter opening through floor or rear wall
Copper tubing recommended between cold water line and water
connection location. Water line tubing recommended is 48" minimum
length by 1/4" diameter. Installation of easily accessible shutoff valve in
water line required.
• Minimum 25-1/4" depth requires recessed electrical outlet and copper
water line.
To allow for ease of installation, tape excess power cord to back of unit.
•
• To allow for ease of moving out side-by-side units after installation, 84"
minimum length of coiled copper tubing recommended.
• When installing freezer adjacent to wall, cabinet or other appliance
that extends beyond front edge of unit, 20" minimum clearance
recommended to allow for optimum 140° door swing, providing
complete drawer / crisper access and removal. (Absolute 4" minimum
clearance will ONLY allow for 90° door swing which will provide limited
drawer / crisper access with restricted removal.)
USA 10200 David Taylor Drive Charlotte, NC 28262
• •
CANADA 5855 Terry Fox Way Mississauga, ON L5V 3E4
• •
FPUH19D7L 02/12
1-800-FRIGIDAIRE frigidaire.com
• •
1-800-265-8352 frigidaire.ca
• •
© 2012 Electrolux Home Products, Inc.
• Freezer must be placed on level surface of hard material, same height
as flooring. Surface must support approximately 800 lbs. when fully
loaded. Unit equipped with 4-point leveling.
"Built-In Look" Specifications
• Minimum opening of 72" H x 33" W x 25-1/4" D required for single-
unit "Built-In Look" installation; 66" W required for double-unit
installation. (72" H to be measured from finished floor to underside
of soffit or overhead cabinet.)
• Remove all wall / floor molding prior to built-in installation.
Optional Trim Kit Specifications
If optional Single or Double Louvered Trim Kit is to be used, different
•
cutout dimensions are required. Kit can be adapted to fit either 75"
or 79" opening height. (Refer to cutout dimensions on this page and
detailed Louvered Trim Kit installation instructions included with kit or
on web.)
• Remove all wall / floor molding prior to built-in installation.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
Optional Accessories
Single Louvered Trim Kit – (PN # TRIMKITEZ1).
•
• Double Louvered Trim Kit – (PN # TRIMKITEZ2).
PureAdvantage® Air Filter
•
Replacement Cartridge – (PN # 241754001).
All Freezer
FPUH19D7L F 19 Cu. Ft.
Specifications
subject to change.