Dymo LabelManager® Wireless PnP Quick Start Manual page 13

To configure the printer on your wireless network
From within the built-in software, click
1
The Wireless Setup tool starts.
Follow the steps in the Wireless Setup tool.
2
The wireless status light located on the top of the label
maker turns solid blue when the label maker is
successfully connected to a wireless network. See
Figure 8.
After configuring the label maker as a wireless printer,
3
disconnect the USB cable from your computer.
Place the printer in an easily accessed location.
4
Plug the USB cable into the wall adapter and then plug the wall adapter into
5
a wall outlet.
If necessary, press the power button to turn the printer on.
6
Adding the Wireless Printer
To print labels to the networked printer, you must download and install DYMO
Label™ v.8.5 or later from the DYMO Web site, and then add the printer to your
computer.
To add the wireless printer to a Windows computer
Download DYMO Label™ v.8.5 or later from the Support section of the
1
DYMO Web site at www.dymo.com.
Close all open Microsoft Office applications.
2
Double-click the Installer icon.
3
After a few seconds, the installation screen appears.
Click Install and follow the instructions in the installer.
4
When the software installation is complete, you are prompted to connect
your printer.
Without connecting your printer, click Finish, and then start the software.
5
.
Wireless
status light
Figure 8
9