Materials And Basic Tools Needed; Material Needed; Basic Tools - Kenmore Powermiser 12 153.331761 Owner's Manual

Materials Needed
To simplify the installation Sears has available the installation parts shown below. You may or may not need all of these materials,
depending on your type of installation.
I H_tbtt, Gtl_
®
FLEXIBLE WATER HEATER GAS
CONNECTOR WITH FITTINGS
METAL DRAIN PANS AVAILABLE IN
20" (508 ram) DIAMETER FOR WATER
HEATERS HAVING A DIAMETER 18" (457
ram) OR LESS, 24" (610ram) DIAMETER
FOR WATER HEATERS HAVING A
DIAMETER 22" (559 turn) OR LESS AND
AVAILABLE IN 28" (711 ram) DIAMETER
FOR WATER HEATERS HAVING A
DIAMETER 26" (660 ram) OR LESS
EXPANSION TANKS FOR THERMAL EXPANSION
CONDITIONS AVAILABLE IN 2 GALLONS
(7.6 LITERS) AND 5 GALLONS (18.9 LITERS)
CAPACITY THROUGH LOCAL SEARS STORE OR
SERVICE CENTER
Basic Tools
You may or may not need all these tools, depending on your
type of installation. These tools can be purchased at your local
Sears Store.
• Pipe Wrenches (2) 14" (356 ram)
• Screwdriver
° Tin Snips
° 6' (1.82 m) Tape or Folding Ruler
• Garden Hose
• Drill
• Pipe Dope or Teflon Tape DRILL
SLOT-HEAD SCREWDRIVER
:_ TIN SNIPS
PHILLmPS SCREWDRmVER
ROLL OF TEFLON
TAPE (USE ONLY ON
WATER HEATER
CONNECTIONS)
PIPE DOPE
(SQUEEZE TUBE)
USE FOR WATER AND GAS
CONNECTIONS
GARDEN HOSE
6 FOOT TAPE
PIPE WRENCH
Additional Tools Needed
When Sweat Soldering
* Tubing Cutters or Hacksaw
* Propane Tank
* Soft Solder
* Solder Flux
° Emery Cloth
° Wire Brushes
TUBING CUTTER
\
1
PROPANE
TORCH
HACKSAW
ROLL OF
EMERY CLOTH
3/4" (19 ram) WIRE BRUSH
1/2" (13 mm) WIRE BRUSH
ROLL OF LEAD=FREE
SOFT SOLDER
8
SOLDER
FLUX