Rear Display Unit Installation; How To Mount The Rear Display Unit - Panasonic JS-950 Series User Manual

■ Rear Display Unit Installation

Be sure to disconnect the power cable of the main block (POS Workstation) and confirm the
power is "OFF" before the operation below.

1. How to mount the rear display unit

(1) Loosen the thumbscrew on the lower portion of the rear cover at the rear display side of the
main unit by hand, and remove the rear cover.
* The thumbscrew shall be loosened until the screw rotates without resistance.
(2) Prepare a rear display to be used. (The contents here explain the 2-line type.)
(3) Connect the hook of the rear display to the hole of the main unit, and tighten the 2
thumbscrews by hand to secure it.
(4) Connect the connector of the rear display with the connector of the main unit.
* The cable connector has a clip to prevent the cable from coming out from the main unit.
(5) Gently press cable toward Display Unit so that it will not extend beyond the case.
In case of installation of 2 line Rear Display module, clamp the cable as shown in the fig.
(5)-1. In case of installation of 4 line Rear Display module, you do not need to clamp cable.
(6) Peel off the blind seal attached on the window of the rear cover.
(7) Attach the rear cover on the main unit, and tighten the thumbscrew on the lower portion by
hand to secure the cover.
(1)-1
(3)-1
(5)-1
(1)-2
(3)-2
(5)-2
8
(2)
( 4)－ １
(4)
(7)