Advertisement
Specifi cations
Model
Power supply
Power consumption
350 W (0.45 W when STANDBY MODE set to ECO,*
Panel size
16.5 mm (0.65 inches) (16:10 aspect ratio)
DLP™
Display method
chip
Pixels
Lens
Lamp
Screen size (diagonal)
1.52 – 2.79 m (60 – 110 inches) (16:10 aspect ratio)
Color reproducibility
Brightness*³
Center-to-corner uniformity*³
Contrast*³
1,280 × 800 pixels (Input signals that exceed this
Resolution
resolution will be converted to 1,280 × 800 pixels.)
HDMI
RGB (analog)
Scanning
frequency
YP
P
(YC
C
)
B
R
B
R
Video/S-Video
Keystone correction range
Installation
Built-in speaker
HDMI IN
COMPUTER IN 1
COMPUTER IN 2 /
MONITOR OUT
VIDEO IN
S-VIDEO IN
Terminals
COMPUTER AUDIO IN
AUDIO IN
AUDIO OUT
SERIAL IN
LAN
(RJ-45) × 1 (for network connection, 100BASE-TX/10BASE-T, compliant with PJLink™ (class 1))
3D SYNC OUT
Cord length
Cabinet materials
Dimensions (W × H × D)
Weight
Noise level
Operating environment
Supplied accessories
Wireless remote control unit x 1, Batteries (AAA type x 2) ,Computer cable (1.8 m, for VGA) x 1
Optional accessories
Ceiling mount
Ceiling mount
bracket
bracket
5
for high ceilings*
for low ceilings*
ET-PKV100H
ET-PKV100S
Bracket assembly
ET-PKC100B
Caution
Do not install the projector in locations that are subject to excessive water, humidity, steam or oily smoke. Doing so may result in fi re, malfunction or electric shock.
NOTE ON USE
1 The projector uses a high-voltage mercury lamp under high internal pressure. This lamp may break, emitting a popping
sound, or fail to illuminate, due to impact or extended use.
2 The high-wattage lamp becomes very hot during operation. Please observe the following precautions:
• Never place objects on top of the projector while it is in operation.
• Make sure there is an unobstructed space of 500 mm (19-11/16 in) or more around the projector's exhaust openings.
• If stacking projector units, care must be taken to provide the recommended space between units. These space
requirements also apply to installation where only one projector unit is operating at one time and the other unit is used
as a backup.
Weights and dimensions shown are approximate. Specifi cations and appearance are subject to change without notice.
Product availability differs depending on region and country. This product may be subject to export control regulations.
The projection distances and throw ratios given in this brochure are for use only as guidelines. For more detailed information, please
consult the dealer from whom you are purchasing the product. The PJLink trademark is an application trademark in Japan, the
United States, and other countries and regions or registered trademarks.
Microsoft
®
, Windows
®
and Windows Vista
®
States and/or other countries. DLP™ (Digital Light Processing), DLP™ Chip, DLP Medallion Logo and DLP
or registered trademarks of Texas Instruments. NVIDIA™, NVIDIA™ Logo and 3D Vision™ are trademarks or registered trademarks
of NVIDIA Corporation in the United States and/or other countries. All other trademarks are the property of their respective
trademark owners. Projection images simulated.
© 2012 Panasonic Corporation. All rights reserved.
PT-CW230
100 – 240 V AC, 50/60 Hz
DLP™ chip x 1
1,024,000 (1,280 x 800) pixels
Fixed/manual focus F = 2.5 f = 4.83 mm
275 W UHM lamp (The lamp replacement cycle is 3,000 hours*
Full color (16.77 million colors)
2500 lm
80%
2000:1 (full on/off)
(Horizontal) 15–93 kHz; (Vertical) 50–120 Hz; (Dot clock) 150 MHz or lower
(Horizontal) 15–93 kHz; (Vertical) 50–120 Hz; (Dot clock) 150 MHz or lower
(Signals exceeding the dot clock rate of 150MHz are downsampled.)
f
: 15.75 kHz, f
: 60 Hz [480i(525i)]
H
V
f
: 31.50 kHz, f
: 60 Hz [480p(525p)]
H
V
f
: 45.00 kHz, f
: 60 Hz [720(750)/60p]
H
V
f
: 33.75 kHz, f
: 60 Hz [1080(1125)/60i]
H
V
(fH) 15.75/15.63 kHz (fV) 50/60 Hz [NTSC/NTSC4.43/PAL/PAL60/PAL-N/PAL-M/SECAM]
Vertical: ± 5°
Ceiling/fl oor, front/rear (Menu setting)
3.7 cm Round shape x1 output power 10 W (Monaural)
(HDMI 19-pin) x 1 (compatible with HDCP)
Audio signal Linear PCM (Sampling frequency: 48 kHz/44.1 kHz/32 kHz)
D-sub HD 15-pin (female) x 1 [RGB/YP
D-sub HD 15-pin (female) x 1 (RGB x 1) (input/output selectable using on-screen Menu)
(When Monitor Out is selected, the COMPUTER IN 1 signal is output.)
RCA pin × 1
Mini DIN 4-pin × 1
M3 x 2 (L-R x 1)
RCA pin x 2 (L-R x 1) for VIDEO/S-VIDEO input
M3 x 1 (L-R x 1)
D-sub 9-pin (female) × 1 for external control (RS-232C compliant)
Mini DIN 3-pin x 1 (for 3D transmitter connection)
3.0 m (9'10")
Molded plastic (PC)
321 x 178 x 386 mm (12-5/8" × 7" × 15-3/16") (with legs at shortest position)
Approx.6.2 kg (13.7 lbs)*
36 dB (Lamp power: Normal); 28 dB (Lamp power: Eco)
Operating temperature: 0° – 40°C(32° – 104°F) (Less than 1000 m above sea level);
0° – 30°C(32° – 86°F) (1000 – 2700 m above sea level)
Operating humidity: 20% - 80% (no condensation)
Power cord x 1( x 2 for PT-CW230EA, PT-CX200EA), Power cord cover x 1,
Wall mount bracket
ET-PKC100W
5
are either registered trademarks or trademarks of Microsoft Corporation in the United
PT-CX200
1
11.0 W when STANDBY MODE set to NETWORK.)
14 mm (0.55 inches) (4:3 aspect ratio)
DLP™ system
786,432 (1,024 x 768) pixels
2
)
1.40 – 2.29 m (55 - 90 inch) (4:3 aspect ratio)
2000 lm
1,024 × 768 pixels (Input signals that exceed this
resolution will be converted to 1,024 × 768 pixels.)
f
: 15.63 kHz, f
: 50 Hz [576i(625i)]
H
V
f
: 31.25 kHz, f
: 50 Hz [576p(625p)]
H
V
f
: 37.50 kHz, f
: 50 Hz [720(750)/50p]
H
V
f
: 28.13 kHz, f
: 50 Hz [1080(1125)/50i]
H
V
(C
)/P
(C
) x 1]
B
B
R
R
4
Replacement lamp unit
Replacement filter unit
ET-LAC100
ET-RFC100
• If the projector is placed in a box or enclosure, the temperature of the air surrounding the projector must match the
operating temperature listed in the specifi cations table during use. Also, make sure the projector's intake and exhaust
openings are not blocked. Ensure there is suffi cient ventilation to prevent hot air from the exhaust openings being
recirculated into the intake opening.
3 The lamp replacement cycle duration becomes shorter if the projector is operated repeatedly for short periods.
• The lamp replacement cycle varies greatly depending on individual lamp characteristics and usage conditions.
• The brightness of the lamp will gradually decrease with use.
4 Due to natural characteristics of lamps, screen brightness may fl uctuate. This is not an indication of faulty lamp performance.
TM
Link™ are trademarks
Projection distance
A
B
F
E
Projected image
E
F
B
A
PT-CW230 (16:10 aspect ratio; throw ratio: 0.19:1)
Distance from
Distance from
the edge of
Diagonal
the projector
the projection
image size
front to the
window to the
screen (B)
screen (A)
1.52 [60"] 0.23 (0.75') -0.07 (-0.23') 0.05 (0.16') 0.23 (0.75')
(0.92') -0.02 (-0.07')
1.78
[70"]
0.28
(1.05') 0.02 (0.07')
2.03
[80"]
0.32
(1.21') 0.07 (0.23') 0.11 (0.36') 0.29 (0.95')
2.29
[90"]
0.37
(1.35')
(0.36')
2.54
[100"]
0.41
0.11
(1.51')
(0.52')
2.79
[110"]
0.46
0.16
PT-CX200 (4:3 aspect ratio; throw ratio: 0.24:1)
Distance from
Distance from
the edge of
Diagonal
the projector
the projection
image size
front to the
window to the
screen (B)
screen (A)
1.40 [55"] 0.25 (0.82') -0.05 (-0.16') 0.07 (0.23') 0.25 (0.82')
(0.92') -0.02 (-0.07')
1.52
[60"]
0.28
(1.08') 0.04 (0.13')
1.78
[70"]
0.33
(1.25') 0.09 (0.30') 0.14 (0.46') 0.32 (1.05')
2.03
[80"]
0.38
(1.44')
(0.46')
2.29
[90"]
0.44
0.14
Dimensions
321(12-5/8)
*1 When Standby mode is set to Eco, network functions such as
standby on via LAN are not available. Only certain commands
can be received for external control using the serial terminal.
*2 This is the maximum value when the lamp power is set to
Eco mode where the lamp is turned on for 2 hours and off
for 0.25 hours. If the lamp is turned on more times or kept
on for a long time, the lamp replacement cycle will shorten.
In Normal mode, the lamp replacement cycle is 2,000 hours.
The usage environment affects the duration of the lamp.
*3 Measurement, measuring conditions, and method of
notation all comply with ISO 21118 international standards.
*4 The above values are averages. Actual values may be
different according to the product.
*5 This product is used together with an optional bracket
assembly (sold separately).
For more information about Panasonic projectors
http://panasonic.net/avc/projector
All information included here is valid as of March 2012.
PT-CW230G1 Printed in Japan.
unit: meters (feet)
Height from
Height from
the edge of
the edge of the
the screen to
screen to the
the top of the
bottom of the
projector (E)
projector (F)
(0.23')
(0.82')
0.07
0.25
(0.30')
(0.89')
0.09
0.27
(0.43')
(1.02')
0.13
0.31
(0.49')
(1.08')
0.15
0.33
Height from
Height from
the edge of
the edge of the
the screen to
screen to the
the top of the
bottom of the
projector (E)
projector (F)
(0.30')
(0.89')
0.09
0.27
(0.36')
(0.95')
0.11
0.29
(0.56')
(1.15')
0.17
0.35
unit: mm (inch)
386(15-3/16)
Advertisement
