Table of Contents
Advertisement
Preparation Before Operation
Remote controller
I I I I I Setting the batteries
Position + and
– correctly!
Address switch
1
1
Press
with a finger and slide the back
cover to take it off.
2
Set two alkaline dry batteries (LR03).
3
Set the back cover as before.
G This will cause the figures on the display to
flash. Set the clock at this point.
ATTENTION
About batteries
G Always replace two batteries at the same
time. Replace them with new ones of an
identical type.
G Do not use manganese dry batteries since
their use may cause a malfunction.
G If you are not going to use the air
conditioner for a long period, take out all
the batteries.
G Batteries should last for about a year
under normal conditions. When you find
the displays unclear and signal
communication often failing, replace them
with new ones.
G Batteries may be exhausted even before
the recommended date of consumption
printed on them, if the air conditioner was
manufactured many months ago.
G Never try to recharge the batteries.
2
3
I I I I I Operating the remote controller
G To use the remote controller, aim the transmitter at
the indoor unit. If there is anything to block signals
between the unit and the remote controller, such as a
curtain, the unit will not operate.
G Do not drop the remote controller. Do not get it wet.
G The maximum distance for communication is about
7 m.
I I I I I To fix the remote controller
holder on the wall
1
Choose a place from where the signals reach
the unit.
2
Fix the holder to a wall, a pillar, etc. with the
screws supplied with the holder.
3
Fit the claw of the holder into the bottom of
the remote controller, and push the remote
controller onto the wall.
2
Push.
1
Set.
G To remove, pull it upwards.
ATTENTION
About the remote controller
G Never expose the remote controller to
direct sunlight.
G Dust on the signal transmitter or receiver
will reduce the sensitivity. Wipe off dust
with soft cloth.
G Signal communication may be disabled if
an electronic-starter-type fluorescent lamp
(such as inverter-type lamps) is in the
room. Consult the shop if that is the case.
G If the remote control signals happen to
operate another appliance, move that
appliance to somewhere else, or consult
the shop.
Receiver
Remote controller
holder
7
Hide quick links:
Advertisement
Table of Contents
