G Off Timer Operation; G On Timer Operation - Daikin FT50GAVAL Operation Manual

Timer Operation
Timer functions are useful for automatically
switching the air conditioner on or off at night or in
the morning. You can also use OFF TIMER and ON
TIMER in combination.
OFF TIMER operation
G Check that the clock is correct.
If not, set the clock to the present time. (See page 8.)
OFF TIMER
1
Press while the air conditioner
is operating.
2
Press until the time setting
reaches the point you like.
G Every pressing of either button increases
or decreases the time setting by 10
minutes. Holding down either button
changes the setting rapidly.
OFF TIMER
3
Press once again.
Then the TIMER lamp lights up.
I I I I I To cancel the timer:
CANCEL
Press .
Then the TIMER lamp goes off.
Notes on OFF TIMER
G NIGHT SET MODE
When the OFF TIMER is set, the air
conditioner automatically adjusts the
temperature setting (0.5°C up in COOL,
2.0°C down in HEAT) to prevent excessive
cooling (heating) for your
pleasant sleep.
12
is displayed.
blinks.
ON TIMER operation
G Check that the clock is correct. If not, set the
clock to the present time. (See page 8.)
1
Press while the air conditioner
is not operating.
2
Press until the time setting
reaches the point you like.
G Every pressing of either button increases or
decreases the time setting by 10 minutes.
Holding down either button changes the
setting rapidly.
3
Press once again.
Then the TIMER lamp lights up.
Combining ON TIMER and OFF TIMER
G A sample setting for combining the two timers is shown below.
(Example)
Present time: 11:00 PM
(The unit operating)
    
OFF TIMER at 0:00 a.m.
    
ON TIMER at 7:00 a.m.
Notes on ON,OFF TIMER
G When TIMER is set, the present time is not
displayed.
G Once you set ON,OFF TIMER, the time setting
is kept in the memory. (The memory is canceled
when remote controller batteries are replaced.)
G When operating the unit via the ON/OFF
Timer, the actual length of operation may vary
from the time entered by the user.(Maximum
approx. 10 minutes.)
ATTENTION
I In the following cases, set the timer again.
G After a breaker has turned OFF.
G After a power failure.
G After replacing batteries in the remote controller.
is displayed.
blinks.
Combined