I Adjusting The Air Flow Direction; G Adjusting The Horizontal Blade (Flap); G Adjusting The Vertical Blade (Louvre); Powerful Operation - Daikin FT18JV1B Operation Manual

Adjusting the Air
Flow Direction
You can adjust the air flow direction to increase
your comfort.
Adjusting the horizontal
blade (flap)
Press .
SWING
G Every time the button is pressed, "
appears or disappears.
.......
The flap automatically
swings up and down.
....... To stop the flap at an
angle you like, press
ON
No display
Notes on flap angles
G When
SWING is selected, the flap swinging range
depends on the operation mode. (See the figure.)
G The real flap angles are differ from the display of
remote controller.
In FAN mode or COOL mode
When stop operation
0˚
Upper limit in cooling
25˚
Lower limit in cooling
When stop operation
20˚
Upper limit in heating
45˚
Lower limit in heating
ATTENTION
G Always use a remote controller to adjust
the flap angle. If you attempt to move it
forcibly with hand when it is swinging,
the mechanism may be broken.
Adjusting the vertical blade
(louvre)
Hold the knob and
move the louvre.
(You will find a
knob on the left-
side and the right-
side blades.)
ATTENTION
G Be careful when adjusting the louvre. Inside
the air outlet, a fan is rotating at a high speed.
10
"
SWING .
In HEAT or FAN mode
POWERFUL
Operation
POWERFUL operation quickly maximizes the
cooling (heating) effect in any operation mode.
You can get the maximum capacity with a touch
of a button.
G Pressing the (POWERFUL) button during
operation starts POWERFUL operation.
G POWERFUL operation ends in 20 minutes.
Then the system automatically operates
again with the settings which were used
before POWERFUL operation.
G During you use "POWERFUL operation", the
other functions will not go on.
1
Press .
I I I I I To cancel POWERFUL operation:
Press .
Notes on POWERFUL operation
G In COOL and HEAT mode
To maximize the cooling and heating effect,
the capacity of outdoor unit must be
increased and the air flow rate be fixed to the
maximum setting.
The temperature and air flow settings are not
variable.
G In DRY mode
The temperature setting is lowered by 3°C
and the air flow rate is slightly increased.
G In FAN mode
The air flow rate is fixed to the maximum
setting.