Depth Adjustment - RotoZip RZ1500 Operating/Safety Instructions Manual

RZ 2610011540 04-10:RZ 2610011540 04-10 4/7/10 8:16 AM Page 20
INSTALLING AND REMOVING THE
JIGSAW HANDLE ATTACHMENT
1. Remove depth guide from the tool.
2. Open the lock lever near the base of the
attachment (figure 2.)
3. Insert your Spiral Saw® with the switch
toward the attachment as shown in (figure 3.)
Press down firmly and squeeze the tool
toward the attachment, making sure the
locking pin engages the corresponding
keyway on the Spiral Saw®.

DEPTH ADJUSTMENT

Loosen the depth adjustment thumb screw
(counter-clockwise) to change the depth of
cut. Slide the base plate to the desired depth
of cut and re-tighten the thumb screw
(clockwise) (figure 6.)
4. Rotate the upper lock lever to the
"UNLOCK" position and squeeze the tool
toward the attachment. With the Spiral Saw®
positioned tight against the attachment,
release the upper lock lever. Make sure both
the lower and upper lock levers are in their
"LOCK" positions (figures 4 & 5.)
To remove the jigsaw handle attachment,
reverse steps 2, 3, and 4.
Operating Instructions