RotoZip DM10 Operating/Safety Instructions Manual

Spiral saw

Advertisement

Operating/Safety Instructions
DM10

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DM10 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for RotoZip DM10

  • Page 1 Operating/Safety Instructions DM10...
  • Page 2 Do not operate DM10 Dust Collection At- cessive heat. tachment without Fan Housing mounted. Operating DM10 without Fan Housing mount- Some dust created by power sanding, sawing, ed may result in personal injury.
  • Page 3 RZ Connect compatible tools RZ1500, SS560VSC, SS565VSC, SS355. RZ2000, RZ1500, SS560vsc. Using tools not compatible with this attach- ** RotoSaw Coupler to be used on RotoZip ment may cause personal injury or property tool model SS355 damage.
  • Page 4: Canister Assembly

    Assembly After changing bits or Disconnect plug making adjust- from the power source ments, make sure the chuck and any other before making any assembly, adjustments adjustment devices are securely tightened. or changing accessories. Such preventive safety measures reduce the risk of starting the shift, causing loss of control, loose rotating tool accidentally.
  • Page 5 3. Install Collet according to diameter of bit to ment without Fan Housing mounted. Oper- be used. ating DM10 without Fan Housing mounted 4. Install Collet Fan by pressing collet lock but- may result in personal injury. ton and rotating Collet Fan clockwise with Always loosen and tight- wrench provided.
  • Page 6 Dust Collection Attach- ment without Fan Housing mounted. Oper- 3. Install Collet according to diameter of bit to ating DM10 without Fan Housing mounted be used may result in personal injury. 4. Install Collet Fan by pressing collet lock but-...
  • Page 7: Installing Bits

    INSTALLING BITS Bit flutes are sharp and DM10 to loosen Collet Fan by turning coun- should be handled with ter clockwise. caution. 3. Remove old bit and insert new bit: Always loosen and tight- a. RotoSaw – insert bit as far as possible en the collet fan with off- b.
  • Page 8: Making A Cut

    Do not operate DM10 Dust Collection Attachment without Fan Housing mounted. Operating DM10 without Fan Housing mounted may result in personal injury.
  • Page 9: Maintenance

    Accessories Do not operate DM10 Dust Collection Attachment with the following accessories, XB-MC1, XC-T1375, XC-T1000, XC-T750, XB-FTH1. Using accessories not compatible with this attachment may cause personal injury or property damage. Your attachment is compatible with the following accessories: Zip®...

Table of Contents