Advertisement
Available languages
Available languages
UNASSEMBLED
PARTS
Keys
11',I
(2) Keys
(1) Oil Drain Tube
For Future Use
(1) Quick
Connect
Slope Sheet
ASSEMBLY
Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes.
TOOLS REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are listed.
(1) 1/2" Wrench
Tire pressure gauge
(2) 7/16" Wrenches
Utility knife
Pliers
When right or left hand ismentioned in this manual, itmeans
when you are in the operating position (seated behind the
steering wheel).
TO REMOVE TRACTOR FROM CARTON
•
For battery and battery cable installation see "RE-
PLACING BATTERY"in the "Service and Adjustments"
section in this manual.
ADJUST
SEAT (See Fig. 2)
Sit in seat.
•
Lift up adjustment lever (A) and slide seat until a com-
fortable position is reached which allows you to press
clutch/brake pedal all the way down.
•
Release lever to lock seat in position.
UNPACK
CARTON
•
Remove all accessible loose parts and parts cartons
from carton.
•
Remove end panels and lay side panels flat.
•
Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING
TRACTOR
FROM
SKID
TO CHECK
BATTERY
(See Fig. 1)
Lift hood to raised position.
NOTE: If this battery is put into service after month and
year indicated on label (label is located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in Maintenance
section of this manual
for charging instructions).
LABEL
li
Fig. 1
5
Fig. 2
NOTE: You may now roll your tractor off the skid. Continue
using the instructionsthat follow to remove the tractor from
the skid.
WARNING: Before starting, read, understand and fol-
low all instructionsin the Operation section of this manual.
Ensure tractor is in a well-ventilated area. Ensure the area
in front of tractor is clear of other people and objects.
TO ROLLTRACTOR
OFF SKID (See Operation
section
for location and function
of controls)
Raise attachment lift lever to its highest position.
•
Release parking brake by depressing
clutch/brake
pedal.
•
Place freewheel control in "TRANSMISSION
DISEN-
GAGED" position.
(See "TO TRANSPORT"
in the
Operation section of this manual.)
•
Roll tractor forward off skid.
•
Remove banding holding the deflector shield up against
tractor.
Continue with the instructions that follow.
Advertisement
