Advertisement
Available languages
Available languages
SERVICE A
ADJ
REPLACING
BATTERY
(See Fig. 40)
_
WARNING:
Do not short battery termi-
nals by allowing a wrench or any other
object to contact both terminals
at the
same time. Before connecting battery,
remove
metal
bracelets,
wristwatch
bands, rings,
etc.
Positive terminal
must be connected
first
to prevent
sparking from accidental grounding.
•
Lift hood to raised position.
•
Remove terminal cover.
•
Disconnect BLACK battery cable then RED battery
cable and carefully remove battery from tractor.
•
Install new battery with terminals in same position as
old battery.
•
Reinstall terminal cover.
•
First connect RED battery cable to positive (+) battery
terminal with bolt and nut as shown. Tighten securely.
•
Connect BLACK grounding cable to negative (-) battery
terminal with remaining bolt and nut. Tighten securely
•
Close hood.
NEGATIVE
(BLACK)
TERMINAL
POSITIVE
(RED)
CABLE
Fig. 40
TO REPLACE
HEADLIGHT
BULB
•
Raise hood.
•
Pull bulb holder out ofthe hole inthe backside ofthe grill.
•
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
•
Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
•
Check wiring.
TO REMOVE
HOOD AND GRILL ASSEMBLY
(See Fig. 41)
•
Raise hood.
•
Unsnap headlight wire connector.
•
Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
•
To replace, reverse above procedure.
HEADLIGHT
WiRE
'k
\
CONNECTOR
ENGINE
Fig. 41
TO ADJUST
THROTTLE
CONTROL
CABLE
The throttle control has been preset at the factory and
adjustment should not be necessary. If adjustment is nec-
essary, see engine manual.
TO ADJUST
CHOKE
CONTROL
The choke control has been preset at the factory and adjust-
ment should not be necessary. If adjustment is necessary,
see engine manual.
TO REPLACE
FUSE
Replace with 20 amp automotive-type
plug-in fuse. The
fuse holder is located behind the dash.
24
Advertisement
