Table of Contents
Advertisement
Item
2. Reference in
Status
Source
Format
V Phase
3. Reference out
Format
V Phase
4. Embedded Audio Enable
SDI out 1
SDI out 2
SDI out 3
SDI out 4
Monitor out
5. Analog Audio Reference Level
Analog 1,2
Analog 3,4
Analog 5,6
26
Menus
Description
Displays the status of the synchronization signal.
No Detection: The synchronization signal cannot be detected.
Locked: Synchronized with specified synchronization signal.
Unlocked: Not synchronized with specified synchronization signal.
Selects the signal to be used as the synchronization signal.
Reference in: Input signal from the REF IN connector.
SDI in 1: Input signal from HD SDI IN connector 1.
Selects the format of the synchronization signal.
HD: HD (3-value sync)
SD: SD (sync or BB)
Specifies the vertical phase of this unit for the input synchronization signal.
–562 to 0 to +562 (for 1080 59.94i/50i)
–375 to 0 to +375 (for 720 59.94P/50P)
Selects the format of the synchronization signal output from the REF OUT
connector.
HD: HD (3-value sync)
SD (BB): SD (BB)
SD (SYNC): SD (sync)
Specifies the vertical phase of this unit for the output synchronization signal.
–562 to 0 to +562 (for 1080 59.94i/50i)
–375 to 0 to +375 (for 720 59.94P/50P)
Embeds audio on HD SDI OUT connector 1. This is enabled under default
settings.
Embeds audio on HD SDI OUT connector 2. This is enabled under default
settings.
Embeds audio on HD SDI OUT connector 3. This is enabled under default
settings.
Embeds audio on HD SDI OUT connector 4. This is enabled under default
settings.
Embeds audio on HD SDI OUT connector M. This is enabled under default
settings.
Selects the reference level for the AUDIO/INTERCOM connector's Analog 1 and
2 input/output.
–20 dBu
0 dBu
+4 dBu
Selects the reference level for the AUDIO/INTERCOM connector's Analog 3 and
4 input/output.
–20 dBu
0 dBu
+4 dBu
Selects the reference level for the AUDIO/INTERCOM connector's Analog 5 and
6 input/output.
–20 dBu
0 dBu
+4 dBu
Target
N
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Advertisement
Table of Contents
