Table of Contents
Advertisement
Item
1. Gen Lock
Source
Status
Reference out Signal
Frame Synchronizer
2. Video Input
Input Phase
SDI in 1
SDI in 2
SDI in 3
3. Audio Input
Audio Control Packet
SDI in 1
SDI in 2
SDI in 3
4. System Status
Main Video Direction
Structure
Network GenLock
Video Format
Signal Direction
Tally
GPIO Group 1
GPIO Group 2
Structure Settings
Network Settings
Firmware Version
5. Stream
Video Stream
Video Stream 1
Video Stream 2
Video Stream 3
Video Stream 4
Audio Stream
Audio Stream 1,2
Audio Stream 3,4
Audio Stream 5,6
Audio Stream 7,8
Audio Stream 9,10
22
Menus
Description
Displays the input source of the synchronization signal.
Displays the synchronization status.
Displays the reference output type.
Displays the operating mode of the frame synchronizer.
Displays the phase and status of the signal input to HD SDI IN connector 1.
Displays the phase and status of the signal input to HD SDI IN connector 2.
Displays the phase and status of the signal input to HD SDI IN connector 3.
Displays the sampling rate of the HD SDI IN connector 1 audio control packets,
asx (synchronous/asynchronous audio), and ACT (active channel).
Displays the sampling rate of the HD SDI IN connector 2 audio control packets,
asx (synchronous/asynchronous audio), and ACT (active channel).
Displays the sampling rate of the HD SDI IN connector 3 audio control packets,
asx (synchronous/asynchronous audio), and ACT (active channel).
Displays the transmission direction of the main line signal.
Displays the transmission mode.
Displays the Leader/Follower of network synchronization.
Displays the format of the video signal.
Displays the transmission direction of the tally signal.
Displays the transmission direction of the GPIO Group 1 signal.
Displays the transmission direction of the GPIO Group 2 signal.
During the connection process, "OK" appears here when the settings on the
partner unit's [Structure] page are correct, and "Error" appears when any of the
settings are not correct.
During the connection process, "OK" appears here when the settings on the
partner unit's [Network] page are correct, and "Error" appears when any of the
settings are not correct.
Displays version information if the firmware versions of the unit and partner
device do not match.
Displays the video signal source of video stream 1.
Displays the video signal source of video stream 2.
Displays the video signal source of video stream 3.
Displays the video signal source of video stream 4.
Displays the audio signal source of audio streams 1 and 2.
Displays the audio signal source of audio streams 3 and 4.
Displays the audio signal source of audio streams 5 and 6.
Displays the audio signal source of audio streams 7 and 8.
Displays the audio signal source of audio streams 9 and 10.
Advertisement
Table of Contents
