Turning The System On/Off - Bose VIDEOWAVE® II ENTERTAINMENT SYSTEM Operating Manual

English TAB 2

Turning the system on/off

Press the power button on
the remote to start the system.
When the system starts up, it also
automatically turns on your set-top
box (cable, satellite, etc.).
The state of the power light on the
control console and monitor
indicates the system status.
While the system starts up, the
monitor emits a start-up tone and
displays the Bose ®
logo with a
progress bar under it.
Note: When you turn the system on, it will always select
and turn on your cable or satellite box.
Note: To keep energy consumption to a minimum, the
system operates in a very low power state when it is off.
This is why the system may take several seconds to start.
To turn off the system, including the connected
source, press the power button.
TAB 3 TAB 4
Power
TAB 5 TAB 6
B S
ASIC YSTEM
Control console power light
Status Meaning
Red Off
Blinking green Starting up
Steady green On and ready to use
Orange Off and charging iPod
Blinking yellow for 30 Unify
seconds after shutting incomplete
system down
Slow blinking red while Unify system setup is complete, but no
system is off sources are present
Red blinking off every 5 Remote control batteries are low
seconds
Monitor power light
Status Meaning
Blinking green Starting up
Steady green Video muted (see page 18)
Slow blinking red Power removed from monitor but not
control console
Slow blinking red to green System is shutting down in 10 seconds
until power is restored due to an error. If the problem persists,
contact Bose. See the contact sheet
included with your system
TAB 7 TAB 8
O
PERATION
®
system setup was started, but is
11