Clearing The Tpm Memory With Dsc; Sampling Tracks Automatically With Cd Scan; The Mix Function; Cd Naming - Blaupunkt München RD 104 Operating Instructions Manual

• Press the CLR button for approxi-
mately 8 seconds until "CLR CD" is
shown in the display.
The TPM memory for this disc is clea-
red.
c) Clearing the TPM memory for all
CDs
• Insert the corresponding disc.
• Switch on TPM.
• Press the CLR button for approxi-
mately 14 seconds until "CLR TPM"
is shown in the display.
The TPM memory for all discs is
cleared.

Clearing the TPM memory with DSC

The DSC function allows you to completely
clear one or several discs from the TPM
memory.
Use the update function to confirm the TPM
programming for all discs to be maintained in
the TPM memory.
• Press DSC.
• Press / until "CD UPD" (update) ap-
pears in the display.
• Press the <</>> button until "LOAD
CD" is displayed.
• Now insert the disc to be maintained in
the TPM memory. The display shows
"READ".
• The display shows "NEXT CD".
• Press EJECT and insert the next disc.
Go through this procedure again for all discs
you wish to maintain in the TPM memory.
• Finally press the TPM button for more
than 2 seconds.
• Quit the DSC mode.
All the discs inserted during this procedure
will be remained in the TPM memory. The
other discs left out are deleted.
Sampling tracks automatically with CD
SCAN
This function allows you to sample all CD
tracks one after another.
To activate the scan function,
• press the PS button for about
2 seconds.
The display shows "CD SCAN".
The following tracks will be scanned one after
another.
If "TPM" is activated, the set will only sample
the tracks stored in the TPM memory.
To continue listening to the sampled track,
• press the PS button once again. The
set will then continue to play the track
currently being sampled.
See also chapter "DSC programming - SCAN-
TIME".

The Mix function

When the Mix function is activated, the CD
tracks will be played at random. The display
will then show "Mix".
If "TPM" is activated, the set will only play the
tracks stored in the TPM memory. To skip a
title, press button .
Press the Mix button to switch "Mix" on and
off.

CD naming

This function allows you to name as many as
30 discs. Each time the corresponding disc is
inserted, the specified name will then be
shown in the display (e.g. VIVALDI).
To start the entry:
• Press the DSC button.
• Set "CD DSP" to "NAME".
• Press the / button until "CD NAME"
is displayed.
• If no disc is inserted, the system will
display "LOAD CD".
• Insert the disc to be named.
The first underscore character is flashing.
• Now use the / button to select a
character.
27