Table of Contents
Advertisement
DrivePedal
The drive pedal is located
on the right side of the
tractor, along the running
board. Depress the
drive pedal forward
and the tractor will move in
the direction
that the shift lever is engaged
in.
To cause the tractor
to travel forward,
while at
a complete
stop, move the shift lever into the
Forward
position.
Gradually
step on the drive
pedal and the tractor will begin to move forward.
To move in Reverse, follow
the same procedure
only move the shift lever into the reverse position.
The ground
speed is controlled
with the drive
pedal. The further
forward
that the pedal is
4e
M
M
W
pivoted,
the faster the tractor will travel. The pedal will return
to its original
position
when it's not depressed.
Refer to the
Operation
section of this manual for detailed
instructions
regarding
the drive pedal.
IMPORTANT:
Always set the parking
brake when leaving the
tractor
unattended.
DeckLift Lever
Found on your tractor's
right fender, the deck lift
lever is used to change the height
of the cutting
deck. To use, move the lever to the left, then place in
the notch best suited for your application.
PTO(BladeEngage) Lever
Found on the tractor's
right fender, the PTO (blade
engage) lever is used to engage
power to the cutting
deck. To operate, move the lever all the way forward.
Moving
the lever all the way rearward
into the PTO
OFF position
disengages
power to the cutting
deck.
NOTE:The
PTO (blade engage) lever must be in the
disengaged
(PTO OFF) position
when starting
the
engine.
z
41_
m
o
w
m
z
o
m
/I
SECTION 4--
CONTROLS & FEATURES
Hide quick links:
Advertisement
Table of Contents
