Speed Control Lever; Pto(Bladeengage)Lever; Decklift Lever - MTD 760 Series Operator's Manual

$hift Lever
The shift lever is located on the left side of the fender and has
three positions, FORWARD, NEUTRAL and REVERSE.The brake
pedal must be depressed and the tractor must not be in motion
when the moving shift lever. See Fig. 4-4.
IMPORTANT: Never force the shift lever. Doing so may result in
serious damage to the tractor's transmission.
F
RUETRAL
Figure 4=4
SpeedControl Lever
The speed control lever, located on the left side of
the tractor's dash console, allows you to regulate
the ground speed of the lawn tractor. To use,
depress the clutch-brake pedal and move the lever
out of the parking brake notch and forward to
increase the tractor's ground speed. When a desired
speed has been reached, release the lever into an
appropriate notch to maintain that speed.
To slow the tractor's ground speed, depress the
clutch-brake pedal and move the speed control
lever rearward and release it into a notch.
NOTE: Lawn tractors vary by model and are
available with either a 6- or 7-speed control lever.
PTO(BladeEngage)Lever
Found on the tractor's right fender, the PTO (blade
engage) lever is used to engage power to the cutting
deck or other (separately available) attachments.
To operate, move the lever all the way forward.
Moving the lever all the way rearward into the PTO
OFF position disengages power to the cutting deck/
attachment.
NOTE:The PTO (blade engage) lever must be in the
disengaged (PTO OFF) position when starting the
engine.
DeckLift Lever
Found on your tractor's right fender, the deck lift lever
is used to change the height of the cutting deck. To
use, move the lever to the left, then place in the notch
best suited for your application.
PARR
BRAKE
Z
ll O
m
o
p.
m
Z
¢)
_'4
SECTION 4 -- CONTROLS AND FEATURES