Filter Replacement - Kenmore Hepa 152.83250 Owner's Manual

FILTER REPLACEMENT
These filters are specially designed for easy replacement at maximum perform-
ance. THE FILTERS ARE NOT WASHABLE.
1. Ttaaa the Air Cleaner OFF and unplug the lmit from the power outlet°
2. Carefiflly lay unit down on a flat surface with ttae Front Grille facing up,
3. Gently push in on Release Buttons on both sides of the unit and swing out
the Front Grille.
4. Remove the filter assembly (consisting of the pre-fiter and HEPA filter) from
the unit.
5. The pre-filter is attached to the HEPA filter frame with hook/loop fasteners
at four comers. Detach pre-fiter and discard it.
6. Remove mad discard any plastic protective wrapping from the new pre-fiter.
Line up new pre-fiter with HEPA filter frame. Lay pre-fiter on HEPA filter and
gently push on its four comers to attach it to the HEPA fr',une. If only replac-
ir',g pre-filter, proceed to step 10.
7. If replacing HEPA as well as pre-_ter, follow instructions through step 5.
Discard used HEPA filter. Note:Always install new pre-fiter when changing
HEPA filter.
8. Remove mad discard may protective plastic wrapping and packaging from
the new HEPA filter.
9. Attach new pre-fiter to new HEPA filter frame
according
to directions in step
&
10. Place the Falter assembly into the mlit and install the Front Grille by engaging
the tabs into the slots, then swinging Grille into assembly position. Push in
gently to snap it into place.
11_ Adjust the filter change wheel(s) to properly indicate when the next filter
change is necessary.
12. "Darn the Air Cleaner upright and plug it into an outlet.The Air Cleatmr is
now ready for opemtion.
MODEL 83250
MODEL 83254
FilterPre-Filter
\
Tabs Buttons
FilterPre-Filter
Slots
Release
Tabs Buttons