Yamaha YFM25RX Owner's Manual page 94

7. Install a new oil filter element.
NOTE:
1
Make sure that the O-rings are properly seated.
2
8. Install the oil filter element cover by installing
the bolts, and then tighten them to the speci-
3
fied torque.
4
Tightening torque:
Oil filter element cover bolt:
5
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
6
9. Install the engine oil drain bolt and tighten it to
the specified torque.
7
Tightening torque:
8
Engine oil drain bolt:
20 Nm (2.0 m·kgf, 14.5 ft·lbf)
9
10. Add the specified amount of the recommend-
10
ed engine oil, and then install and tighten the
engine oil filler cap.
11
Recommended oil:
See page 10-1.
Oil quantity:
Without oil filter element replacement:
1.25 L (1.32 US qt) (1.10 Imp.qt)
With oil filter element replacement:
1.35 L (1.43 US qt) (1.19 Imp.qt)
NOTE:
Be sure to wipe off spilled oil on any parts after the
engine and exhaust system have cooled down.
ECB00300
CAUTION:
G
In order to prevent clutch slippage (since the
engine oil also lubricates the clutch), do not
mix any chemical additives. Do not use oils
with a diesel specification of "CD" or oils of
a higher quality than specified. In addition,
do not use oils labeled "ENERGY CONSERV-
ING II" or higher.
G
Make sure that no foreign material enters the
crankcase.
11. Start the engine, and then let it idle for several
minutes while checking it for oil leakage. If oil
8-14