Yamaha VXS: VXR Owner's Manual page 90

Maintenance
TIP:
Be careful not to drop the plastic tie into the
engine compartment.
1
1 Breather hose
2 Plastic tie
(3) Remove the engine cover screws.
1 Engine cover screw
(4) Lift up the engine cover and remove it.
1 Engine cover
85
2
1
1
To install the engine cover:
(1) Lift up the breather hose so that it will not
be routed under the engine cover, place
the engine cover in its original position,
and then push it down.
1
2
1 Engine cover
2 Breather hose
(2) Install the engine cover screws, and then
tighten them to the specified torque.
Tightening torque:
Engine cover screw:
4.5 Nm (0.46 kgf-m, 3.3 ft-lb)
(3) Slide the corrugated tube on the breather
hose toward the bow until it stops, and