Emergency Starting Engine - Yamaha F9.92 Owner's Manual

Trouble Recovery
engine is running. Do not install the
starter mechanism or top cowling after
the engine is running.
Do not touch the ignition coil, spark
G
plug wire, spark plug cap, or other elec-
trical components when starting or op-
erating the motor. You could get an
electrical shock.
EMU29602

Emergency starting engine

1. Remove the top cowling.
2. Remove the cable by pulling out it from
the starter, if the cable is equipped.
1. Start-in-gear protection cable
3. Remove both ends of the choke link rod.
1. Choke link rod
4. Remove the starter/flywheel cover after
removing the 3 bolts. Disconnect the
wire leads from the starter/flywheel cov-
79
5.
1
ZMU02069
1
ZMU02332
6.
er.
Prepare the engine for starting. For fur-
ther information, see page 30. Be sure
the engine is in neutral and that the en-
gine stop switch lanyard lock plate is at-
tached to the engine stop switch.
Pull up the lever on the carburetor to op-
erate the choke system when the engine
is cold. After the engine starts, return the
lever to the original position.
ZMU02070
ZMU02026
ZMU02334