Yamaha AR210 Owner's Manual page 38

2
F
EATURES
reduce the value. Press and release
either key to change the value in 1-
foot increments. Press and hold the
key to change the value in 9-foot
increments per second.
3) After your selection is made, the
display will return to normal opera-
tion after 5 seconds.
4) The Alarm indicator and Shallow
Alarm indicator will now be present.
Setting the Deep Alarm
The Deep Alarm function can be set for
depths ranging from 3 to 199 feet (1 to
60.3 meters). When the depth is more
than the chosen setting, the alarm is
triggered. The alarm sounds an audible
"alarm" for 10 seconds while flashing
the Warning LED, as well as the Alarm
indicator and the Deep Alarm Indicator
on the display.
After 10 seconds the audible alarm
mutes and the Warning LED and the
indicators continue to blink until the
depth decreases, or the alarm is reset.
NOTE: Set the Deep Alarm function
each time you wish to use it. The gauge
does not retain the setting after the
main switch is turned off.
1) Press the "DOWN" key located on
the front of the display. The current
alarm setting will be displayed on
the display. "000" is the default set-
ting (no alarm function).
& F
UNCTIONS
2) Press the "UP" key within 5 seconds
to increase the selected value
(more water depth). Press the
"DOWN" key to reduce the value.
Press and release either key to
change the value in 1-foot incre-
ments. Press and hold the key to
change the value in 9-foot incre-
ments per second.
3) After your selection is made, the
unit will return to normal operation
after 5 seconds.
4) The Alarm indicator and Deep
Alarm indicator will now be present.
5. Warning Indicators
There are three warning indicators
in each tachometer to alert you
about certain conditions on your
boat. These warnings correspond to
the engine monitored by the
tachometer.
Check Engine – If a sensor mal-
function or a short circuit is detect-
ed, the warning indicator will come
on. If this occurs, reduce engine
speed and return to shore. Have a
Yamaha dealer check the engine
and circuits.
Engine Overheat – This model is
equipped with an engine overheat
warning system. See the following
section for an explanation.
Oil Pressure – If oil pressure does
not rise to specification, the oil pres-
sure warning indicator comes on. At
the same time, engine speed reduc-
tion control is activated, limiting
maximum speed to 3000 rpm. If this
occurs, reduce engine speed and
return to shore. Have a Yamaha
2-12