Connecting A Computer To The Projector - IBM ILM300 User Manual

3. Make sure the projector is unplugged and your computer is turned off.
DANGER
Electrical current from power, telephone, and communication cables is hazardous.
To avoid a shock hazard:
— Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration of this
product during an electrical storm.
— Connect all power cords to a properly wired outlet.
— Connect to properly wired outlets any equipment that will be attached to this product.
— When possible, use one hand only to connect or disconnect signal cables.
— Never turn on any equipment when there is evidence of fire, water, or structural damage.
— Disconnect the attached power cords, telecommunications systems, networks, and modems before you open
the device covers, unless instructed otherwise in the installation and configuration procedures.
— Connect and disconnect cables as described in the following table when installing, moving, or opening covers
on this product or attached devices.
To connect:
1. Turn everything OFF.
2. First attach all cables to devices.
3. Attach signal cables to connectors.
4. Attach power cords to outlet.
5. Turn device ON.
Note: If you are connecting the projector to a computer, make sure that the distance between the
computer and the projector is 6 feet or less.
1 Audio in

Connecting a computer to the projector

The projector comes with an computer cable. If your computer has a digital output port, you can use the
optional digital computer cable, which is sold separately. See "Accessories" on page 25 for ordering
4
IBM iLM300 MicroPortable Projector: User's Guide
2 S-Video
To disconnect:
1. Turn everything OFF.
2. First, remove power cords from outlet.
3. Remove signal cables from connectors.
4. Remove all cables from devices.
3 Video 4 Computer/USB mouse