Huffy N1-506 Owner's Manual page 8

ONCE POLE SECTIONS ARE POUNDED TOGETHER- THEY CANNOT BE TAKEN APART
Align poles using alignment marks. First, pound top and
2.
middle poles together by bouncing them on a scrap piece of
wood on the ground as shown in FIG B. until they no
longer move toward pole identification stickers. THEN add
bottom pole section and pound together in the same way.
FIG B.
scrap wood
(Not Supplied)
P/N 21273401 07/28/04
IMPORTANT!
CAUTION!
THE IDENTIFICATION STICKER IS
LOCATED 5" FROM THE END OF
THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE POLE
SECTIONS SHOULD HAVE A 3-1/2"
MINIMUM OVERLAP, LEAVING 1-
1/2" BETWEEN THE OVERLAPPING
POLE AND THE IDENTIFICATION
STICKER.
IDENTIFICATION
STICKER
IDENTIFICATION
STICKER
5"
middle pole
1-1/2"
middle pole
Toll-Free Customer Service Number for U.S. : 1-800-558-5234
8
http://www.huffysports.com
alignment mark
TOP
4
alignment mark
MIDDLE
5
alignment mark
BOTTOM
6