Cisco Nexus 6000 Installation Manual page 50

Connecting to an Ethernet Port
S e n d d o c u m e n t a t i o n c o m m e n t s t o n e x u s 5 k d o c s @ c i s c o . c o m .
If the cable does not remove easily, ensure that any latch present on the cable has been released before
Caution
continuing.
To remove the cable, follow these steps:
Attach an ESD-preventive wrist strap and follow its instructions for use.
Step 1
Press the release latch on the cable, grasp the connector near the connection point, and gently pull the
Step 2
connector from the transceiver.
Either install a replacement cable in the transceiver (see the
Step 3
section on page
cable.
Cisco Nexus 6000 Series Hardware Installation Guide
3-6
3-5) or insert dust plugs into the cable end of the transceiver and the end of the removed
Chapter 3 Connecting the Switch
"Installing a Cable into an Transceiver"
OL-15902-01